PIR sensor 30cm with a connector

- the cable length for the PIR sensor must be of 30cm with a connector on the cable 10cm away from the sensor.

- the diameter of the connector must be smaller than that of the PIR sensor in order to pass through the hole in the top of the furniture.

- the cable exit direction from the board must be parallel to the board like in the picture below

- adhesive tape on the back

• The pir must be as shown in the image, i.e. with an external sensor. 
• They need a release connector on the sensor cable 10cm from the sensor. The diameter of the connector must be smaller than that of the pyro in order to pass through the hole in the top of the furniture
• Soft ON and SOFT OFF (3 seconds fade in and fade out). We must keep the light on for 20 seconds after the last detection and then fade out
• Input12-24V Output max 3A
• If the 24V input fails, when it return the light must stay off until the next detection.
• PCB size 30 * 10mm